Flash On Time - Wasp WWS650 Product Reference Manual

Flash On Time

This feature specifies the ON time for the indicator LED while in Flash Mode. The selectable
range is 100 to 9,900 milliseconds (0.1 to 9.9 seconds), in 100 millisecond increments.
Follow these instructions to set this feature.
1. Determine the desired setting in milliseconds.
2. Divide the desired setting by 100 (setting is in 100ms increments). Pad the result with
leading zeroes to yield two digits. For example: 0 = 00, 5 = 05, 20 = 20, etc.
3. Go to page 78
ming Mode.
4. Scan the bar code: SELECT FLASH ON TIME SETTING.
5. Scan the appropriate two digits from the keypad in
duration which was determined in the steps above. You will hear a two-beep indication
after the last character.
If you make a mistake before the last character, scan the CANCEL bar code to abort and
not save the entry string. You can then start again at the beginning.
NOTE
6. Scan the ENTER/EXIT PROGRAMMING MODE bar code to exit Programming Mode.
This completes the procedure. See
Table 41. Flash On Time Setting Examples
STEP ACTION
1 Desired Setting
Divide by 100 (and pad with
2 leading zeroes to yield two
digits)
3 Scan ENTER/EXIT PROGRAMMING MODE
4 Scan SELECT FLASH ON TIME SETTING
Scan Two Characters From
5
Appendix D, Keypad
6 Scan ENTER/EXIT PROGRAMMING MODE
260
and scan the ENTER/EXIT PROGRAMMING MODE bar code to enter Program-
Table 41
EXAMPLES
'0' and '5'
Appendix D, Keypad
for examples of how to set this feature.
500ms 1,000ms (1 sec.) 5200ms (5.2 sec.)
05 10
'1' and '0'
representing the
9,900ms (9.9 sec.)
52 99
'5' and '2' '9' and '9'
Wasp WWS650