Wasp WWS650 Product Reference Manual page 247

NAK Character
This setting specifies an ASCII character or hex value to be used as the NAK character. ASCII
characters or any hex value from 0 to 0xFF can be selected.
Setting to previously defined characters such as XON, XOFF, or host commands conflicts
with normal operation of these characters. 8-bit data is not recognized when the option
Data Bits
NOTE
To set this feature:
1. Determine the desired character or value.
2. Use the ASCII Chart
the desired character/value.
3. Go to page 33
ming Mode.
4. Scan the bar code: SELECT NAK CHARACTER SETTING.
5. Scan the appropriate two alphanumeric characters from the keypad in
pad, that represent the desired character/value in step 1 above. The second character will
cause a two-beep indication.
6. Scan the ENTER/EXIT PROGRAMMING MODE bar code to exit Programming Mode.
This completes the procedure. See
Table 27. NAK Character Setting Examples
STEP ACTION
1 Desired Character/Value
Hex equivalent from ASCII
2
Chart
3 Scan ENTER/EXIT PROGRAMMING MODE
4 Scan SELECT NAK CHARACTER SETTING
Scan Two Characters From
5
Appendix D, Keypad
6 Scan ENTER/EXIT PROGRAMMING MODE
Product Reference Guide
has been set as 7 Data Bits.
on the inside back cover of this manual to find the hex equivalent for
and scan the ENTER/EXIT PROGRAMMING MODE bar code to enter Program-
Table 27
EXAMPLES
'1' and '5'
for some examples of how to set this feature.
NAK $
0x15 0x24
'2' and '4'
Appendix D, Key-
@
0x40 0x3E
'4' and '0' '3' AND 'E'
>
237