Table of Contents
Advertisement
X-STREAM X2
Label
Off
Switches the assigned component (valve or pump) off.
On
Switches the assigned component (valve or pump) on.
Test
Switches the assigned component (valve or pump) on and off every second.
V1
Valve at selected gas inlet is assigned the value "V1"
V2
Valve at selected gas inlet is assigned the value "V2"
V3
Valve at selected gas inlet is assigned the value "V3"
V4
Valve at selected gas inlet is assigned the value "V4"
V5
Valve at selected gas inlet is assigned the value "V5"
V6
Valve at selected gas inlet is assigned the value "V6"
V7
Valve at selected gas inlet is assigned the value "V7"
V8
Valve at selected gas inlet is assigned the value "V8"
The gas inlet is a sample gas inlet. The valve assigned to it is controlled via
the Sample software option.
Note!
Sample
There is only one option Sample . This means that in order to control two sam-
ple gas valves during autocalibration, the value Sample must be assigned to
two inlets. During calibration, both valves are then controlled synchronously.
The pump is controlled by the Pump software option.
Note!
Pump
There is only one option Pump. This means that in order to control two pumps
during autocalibration, the lines "Pump1" and "Pump2" must be assigned the
value Pump. During calibration, both pumps are then controlled synchronously.
Tab. 6-4: Parameter IntSHS options
Note!
Each virtual valve V1 to V8 is normally only
assigned to one gas inlet, "Gas1" to "Gas8".
Double assignments are possible, but only
meaningful if the unit is configured accordin-
gly.
6-42
6.2 Menu System - IntSHS Menu
Description
. This means that in order to control two sam-
Chapter 7 includes detailed descriptions
of the configuration and execution of calibra-
tions with valves.
Emerson Process Management GmbH & Co. OHG
Instruction Manual
HASX2E-IM-HS
10/2012
Advertisement
Table of Contents
Troubleshooting
