X-STREAM X2
7.5.2
Opening X-STREAM Analyzers
7.5.2.1 How to Open X-STREAM X2GP
Remove the top cover after loosening the 12
screws.
Fig. 7-9:
7.5.2.2 How to Open X-STREAM X2GK
If your instrument is equipped with a handle
•
loosen the 6 screws at the front panel,
•
to only get access to the cover screws,
push frame and handle about 2 cm / 1"
towards the rear.
Note!
To completely remove frame and handle,
you need to disconnect all gas and electrical
connections and push frame and handle over
the rear panel.
•
remove the 4 screws for the cover,
(2 screws on each side of the instrument
•
push the cover towards the rear and re-
move it.
Fig. 7-10: X-STREAM X2GK
7-44
7.5
Replacing Worn Out Sensors
X-STREAM X2GP
Instruction Manual
12 screws on top
of the instrument
Emerson Process Management GmbH & Co. OHG
HASX2E-IM-HS
10/2012