Emerson Rosemount Analytical X-STREAM X2 Series Instruction Manual page 233

Instruction Manual
HASX2E-IM-HS
10/2012
RawRef

RawMeas
Ref/Meas
CO2.1
Page 3
TempSensor

FlowSensor
SrcCurrent
Page 4
Multi-channel unit:
Press the  key to enter the SELECT COM-
PONENT menu to select a different channel.
Emerson Process Management GmbH & Co. OHG
6.2 Menu System - Status Menu
2.000000
1.000000
2.000000
134.1 ppm
50 °C
1 l/min
1000 mA
Multi-channel unit:
Select the component in the SELECT COM-
PONENT menu.
Displays the raw reference value of the de-
tector (for selected measurement principles
only).
Displays the raw measuring value of the de-
tector. This is the signal without linearisation,
compensation or conversion.
Ratio of RawRef to RawMeas. This value can
be used for diagnostic purposes.
Current measurement value in the user-
defined measurement unit.
If a temperature sensor is assigned to the
selected channel, this line shows the current
temperature.
If a flow sensor is assigned to the selected
channel, this line shows the current gas flow.
If the selected channel is an IR channel, this
line shows the IR source current.
Note!
A value of 0 in one or both of the first two
lines of page 4 is not necessarily an error.
Depending on the measuring procedure used,
a value of 0 may be valid.
At maximum 8 secondary values (pressure,
temperature, flow, source current) can be
shown. Source current values are shown only
if this limit is not yet reached.
X-STREAM X2
6-59