Table of Contents
Advertisement
4.3.1 O
sensor input / Input method of O
2
thermocouple
Terminal block
for communication
(TM2)
External terminal
block
(TM1)
Note 1:
Fix the exclusive cable (O
that its sheath is 10 mm or less.
When attaching the nut, turn it by hand until it does not move and then tighten it with a spanner
by about 1/4 turn.
4.3.2 Cable gland and input and output lines
For sensor signal
INZ-TN1ZKME-E
4.3 Wiring to terminals
sensor input / O
2
For communication
For contact In/Out
For sensor power
sensor
2
c
Oxygen Analyzer
MODE
ESC
ENTER
POWER
sensor thermocouple input) with the cable gland so
2
For Other
For output
- 11 -
Grounding terminal
Main ground wire
Power cable
For power supply
Advertisement
Table of Contents
