Calibration Menu; Automatic Calibration Setting (Option) - Fuji Electric ZKME Instruction Manual

10.2.1 Automatic calibration setting (option)

Description
 You can set the automatic calibration to valid or invalid using this function.
 If changing the automatic calibration setting from valid to invalid during automatic calibration or
remote calibration, the calibration is forcibly canceled.
Operation
(example)
Key operation
(1)
(2)
(3)
(4)
(5)
Note
 If the time for automatic calibration comes during manual treatments (calibration, blowdown, sensor
check, or sensor recovery) or remote treatments (calibration, blowdown, or heater off), the treatment
being performed is prioritized and the automatic calibration starts after the treatment is completed.
 If the time for automatic calibration comes at the same time with automatic blowdown, the automatic
blowdown starts first and the automatic calibration starts after the automatic blowdown is completed.
 If "Prohibition of calibration" is set in the contact input setting and the contact input is on, automatic
calibration is not performed.
 If disconnection is detected (O
(combustion control: option)), or a heater temperature error or A/D saturation error occurs, automatic
calibration is not performed.
INZ-TN1ZKME-E

10.2 Calibration menu

Setting the automatic calibration to valid
Display the screen on the right in accordance with the key
operation summary and press the
Press the key.
The auto calibration valid/invalid setting screen appears.
Use the key to select the auto calibration valid (YES).
Press the key to set the value.
Press the key.
The display returns to the screen on the right.
sensor input, O
2
Description
key.
sensor thermocouple input, or thermocouple input
2
- 53 -
Displayed message
(LCD)
CALIBRATION MENU
SET AUTO CAL
SET AUTO CAL
AUTO CALIBRATION
AUTO CALIBRATION
YES NO
AUTO CALIBRATION
YES
SET AUTO CAL
AUTO CALIBRATION