Heel Guard And Footpeg Mounts: Ulysses Models - Buell XB 2010 Service Manual

HOME
HEEL GUARD AND FOOTPEG MOUNTS:
ULYSSES MODELS
RIDER FOOTPEGS
Footpeg Removal
1. See Figure 2-180. Remove clip (3).
2. Remove footpeg pin (8).
3. Remove footpeg (10) and spring (9).
Footpeg Installation
1. See Figure 2-180. Fit spring ends to footpeg mount and
footpeg.
2. Hold footpeg (10), controlling spring, to footpeg mount (1).
3. Install footpeg pin (8) through mount, spring and footpeg.
4. Install clip (3).
PASSENGER FOOTPEGS
Footpeg Removal
1. Remove clip (3).
2. Remove footpeg pin (8).
3. Remove footpeg (4), detent plate (5), ball (6) and spring
(7).
Footpeg Installation
1. Position footpeg (4), detent plate (5), ball (6), and spring
(7) on to footpeg mount (1).
2. Install footpeg pin (8).
3. Install clip (3).
4. Check that footpeg clicks in the up and down position.
sm03636
5
4
7
6
3
10
1. Footpeg mount
2. Footpeg mount fasteners (3)
3. Clip, footpeg
4. Passenger footpeg
5. Detent plate
6. Ball
7. Spring
8. Pin
9. Spring
10. Rider footpeg
Figure 2-180. Rider Footpeg, Mount and Heel Guard
Assembly: Ulysses
MOUNT REMOVAL
1. On the right side Remove the rear brake pedal fastener.
See 2.11 BRAKE PEDAL.
2. See Figure 2-178. Remove footpeg mount fasteners (2).
3. See Figure 2-182. On the right side, remove the 2
fasteners holding the rear brake master cylinder to the
mount.
4. Remove two fasteners from rear brake line bracket.
5. Remove footpeg mount (1).
MOUNT INSTALLATION
1. On the right side, install the rear brake master cylinder.
See 2.12 REAR BRAKE MASTER
2. Install rear brake line bracket. Tighten fasteners to 48-72
in-lbs (5.4-8 Nm).
3. See Figure 2-178. Position footpeg mount (1).
2010 XB Service: Chassis 2-135
2.35
8
1
2
8
9
3
CYLINDER.