Installation; Ulysses; Remove - Buell XB 2010 Service Manual

HOME
NOTE
In next step, reflector bracket (3) will be removed with turn
signal (1).
4. Remove turn signal from center tail section (5).

Installation

1. See Figure 6-51. Insert bullet connectors through center
tail section.
2. Install reflector bracket.
NOTE
Be sure tab on turn signal fits into hole in reflector bracket and
tab on reflector bracket fits into hole in enter tail section.
3. See Figure 6-54. Attach turn signal using lockwasher and
jam nut (4). Tighten to 25-28 in-lbs (2.8-3.2 Nm).
4. Attach bullet connectors on turn signal wires as shown in
Figure 6-51.
sm00455a
2
1
1. Turn signal (2)
2. Turn signal bulb

ULYSSES

Remove

1. Remove seat. See 2.51 SEAT.
2. See 6.19 LICENSE PLATE LAMP ASSEMBLY,
Remove rear wire cover.
3. See Figure 6-52. Separate left turn signal connector [18]
and right turn signal connector [19].
4. See Figure 6-55. Remove jam nut and lockwasher (4).
5. Remove turn signal from license plate bracket (5).
Installation
1. See Figure 6-55. Insert bullet connectors through license
plate bracket.
6-44 2010 XB Service: Electrical
Be sure that all lights and switches operate properly before
operating motorcycle. Low visibility of rider can result in
death or serious injury. (00316a)
5.
6.
5
3
6
3. Reflector bracket
4. Jam nut and lockwasher (2)
Figure 6-54. Rear Turn Signals: Lightning
Be sure tab on turn signal fits into hole in reflector bracket and
tab on reflector bracket fits into hole in enter tail section.
2.
Ulysses.
3.
4.
Be sure that all lights and switches operate properly before
operating motorcycle. Low visibility of rider can result in
death or serious injury. (00316a)
Check turn signals for proper operation. If operation fails,
reread procedure and verify that all steps were performed.
a. Turn ignition key switch to ON.
b. Activate left turn signals using switch on left
handlebar. Front and rear left turn signals must flash.
c. Activate right turn signals using switch on left
handlebar. Front and rear right turn signals must flash.
d. Turn ignition key switch to OFF.
Install seat. See 2.51 SEAT.
3
6
4
5. Center tail section
6. Bungee hooks
NOTE
Attach turn signal using lockwasher and jam nut (4).
Tighten fastener to 25-28 in-lbs (2.8-3.2 Nm).
Attach bullet connectors on turn signal wires as shown in
Figure 6-52.
Install wire cover. See 6.19 LICENSE PLATE LAMP
ASSEMBLY, Ulysses.
1