Buell XB 2010 Service Manual page 104

HOME
50A) and WHEEL
INSTALLER (Part No. HD-44060C).
a. Sparingly apply EXTREME PRESSURE LUB-
RICANT (Part No. J-23444-A) to the threads of the
short forcing screw (1) to prolong service life and
provide smooth operation.
b. Assemble the short forcing screw (1), nut (2), bearing
(3), washer (4) and bridge (5).
c. See Figure 2-6. Insert the FRONT WHEEL BEARING
REMOVER COLLET (Part No. B-43993-7, from kit
Part No. B-43993-50A) into the wheel bearing until it
fully seats against the bearing.
d. Insert the ball bearing (2) into the collet (1).
e. See Figure 2-7. Thread the puller assembly (1) into
the collet (2).
f. Hold the collet (2), and turn the forcing screw (3) to
expand the collet.
g. See Figure 2-8. Place the bridge (1) against the wheel
hub.
h. Hold the forcing screw (3), and turn the nut (2) clock-
wise until the bearing is free of the hub.
i. See Figure 2-9. Loosen the nut (1), and back off the
bridge (2). Hold the forcing screw (3) while holding
the collet (4) to remove the forcing screw from the
collet.
j. Remove the ball bearing (5) and wheel bearing (6)
from the collet (4).
sm00512
4
3
2
1
1. Short forcing screw
2. Nut
3. Bearing
4. Washer
5. Bridge
Figure 2-5. Assemble Puller
2-24 2010 XB Service: Chassis
BEARING REMOVER AND
5
sm00513
1. Collet
2. Ball bearing
Figure 2-6. Install Collet and Ball Bearing
sm00514
3
1. Puller assembly
2. Collet
3. Forcing screw
Figure 2-7. Expand the Collet
1
2
1
2