Buell XB 2010 Service Manual page 320

HOME
the piston could score the cylinder during engine operation and
cause engine damage.
sm00156
1
1. Piston pin retaining ring
2. Piston pin retaining ring installer
Figure 3-71. Removing Piston Pin Circlip
8. See Figure 3-71. Remove the piston pin circlip as follows:
a. Insert the PISTON
INSTALLER (Part No. HD-34623C) into the piston
pin bore until claw on tool is positioned in slot of piston
(directly under circlip).
b. Squeeze the handles of the tool together and pull
from bore. In the event that the circlip should fly out,
hold a shop towel over the bore during removal.
Remove circlip from claw and discard.
NOTES
It is not necessary to remove both piston pin circlips during
piston removal. Leave the second circlip in the pin bore.
Since the piston pin is a loose fit in the piston, the pin will
easily slide out. The pin has tapered ends to help seat the
round retaining rings.
3-52 2010 XB Service: Engine
2
PIN RETAINING RING
sm00157
Figure 3-72. Piston Pin and Piston Identification
NOTE
See Figure 3-72. The arrows on the pistons must always point
toward the front of the engine.
sm00158
Figure 3-73. Removing Piston Rings
9. See Figure 3-73. Using a piston ring expander to remove
piston rings, spread rings until they clear grooves in piston
and lift off.
CLEANING AND INSPECTION
PART NUMBER
HD-33446-86 XL EVOLUTION TORQUE PLATE
BOLTS
HD-33446B CYLINDER TORQUEPLATES
Compressed air can pierce the skin and flying debris from
compressed air could cause serious eye injury. Wear
safety glasses when working with compressed air. Never
use your hand to check for air leaks or to determine air
flow rates. (00061a)
TOOL NAME