Buell XB 2010 Service Manual page 480

HOME
sm00360
Figure 6-2. Cable Straps On Upper Fork Clamp: Firebolt
sm00363
1. Headlights (2)
2. Cable strap
3. Ignition switch connector [33]
Figure 6-4. Ignition Switch Connector (Viewed From Beneath Fairing): Firebolt
Disassembly
1. See Figure 6-5. Remove ignition switch housing (5) from
ignition switch (4) by prying tabs on side of housing.
2. Remove ignition switch body fasteners (1). Separate igni-
tion switch body (2) from ignition switch (4).
Assembly
NOTE
See Figure 6-5. In next step, be sure wide slot in ignition switch
housing (5) is installed over wide boss on ignition switch (4).
6-6 2010 XB Service: Electrical
sm00361
3
2
1
1. Upper fork clamp pinch fastener (2)
2. Stem pinch fastener
3. Stem capnut
4. Upper fork clamp
Figure 6-3. Upper Fork Clamp: Firebolt
2
1
1. Push ignition switch housing (5) on to ignition switch (4).
In next step, do not force ignition switch (4) into ignition switch
body (2). If ignition switch does not easily slide into ignition
switch body, rotate slot in ignition switch body with screwdriver
until proper installation can be achieved.
2. Mate ignition switch to ignition switch body.
3. Install ignition switch body fasteners (1). Tighten to 12-36
in-lbs (1.4-4 Nm).
1
4
3
NOTE