Lightning; Removal - Buell XB 2010 Service Manual

HOME
Be sure that all lights and switches operate properly before
operating motorcycle. Low visibility of rider can result in
death or serious injury. (00316a)
sm00404a
2
1
1. Turn signal
2. Turn signal bulb
3. Reflector bracket

LIGHTNING

Removal

1. Remove seat. See 2.51 SEAT.
5. Check turn signals for proper operation. If operation fails,
reread procedure and verify that all steps were performed.
a.
b.
c.
d.
6. Install tail frame upper bodywork. See
TAIL ASSEMBLY AND BODY WORK:
7. Install seat. See
7
6
5
4
3
4. License plate bracket
5. Lockwasher (2)
6. Fastener (2)
Figure 6-53. Rear Turn Signals: Firebolt
2. See
[19] on turn signal wires.
3. See
Turn ignition/key switch to ON.
Activate left turn signals using switch on left
handlebar. Front and rear left turn signals must flash.
Activate right turn signals using switch on left
handlebar. Front and rear right turn signals must flash.
Turn ignition/key switch to OFF.
2.51 SEAT.
7. Tail section
Figure 6-51. Disconnect bullet connectors [18] and
Figure 6-54. Remove jam nut and lockwasher (4).
2010 XB Service: Electrical 6-43
2.39 SUBFRAME
FIREBOLT.