Installation - Buell XB 2010 Service Manual

HOME
sm03877
3
1. Upper module
2. Left module
3. Right module
Figure 2-173. Front Modules: Ulysses

INSTALLATION

1. Install right front module leaving single fastener loose.
2. After installing the left front module and aligning with holes
in upper triple clamp, tighten previously installed single
fastener to 12-14 ft-lbs (16.3-19 Nm).
2-128 2010 XB Service: Chassis
3. Attach front brake line p-clamp to rear of right front module
and tighten fastener to 36-60 in-lbs (4-6.8 Nm).
4. Install ignition switch. See
1
SWITCH.
5. Install
6.25 INSTRUMENT
6. Connect turn signals. See
2
7. See Figure
module. Tighten fasteners to 36-60 in-lbs (4-6.8 Nm).
8. Connect speedometer.
9. On Ulysses model, connect auxiliary outlet.
10. Install headlamp assembly and support bracket. See
2.26 HEADLAMP ASSEMBLY AND SUPPORT
11. Install windshield and windscreen. See
AND WINDSCREEN: LIGHTNING AND ULYSSES
MODELS.
Connect positive (+) battery cable first. If positive (+) cable
should contact ground with negative (-) cable connected,
the resulting sparks can cause a battery explosion, which
could result in death or serious injury. (00068a)
12. Connect battery cables to battery: positive cable (red) first.
Tighten to 60-70 in-lbs (6.8-7.9 Nm). See
MAINTENANCE.
After installing seat, pull upward on seat to be sure it is
locked in position. While riding, a loose seat can shift
causing loss of control, which could result in death or
serious injury. (00070b)
13. Install seat.
6.3 IGNITION/HEADLAMP KEY
and connect instrument
MODULE.
6.14 FRONT TURN
2-173. On Ulysses models, install upper
2.48 WINDSHIELD
module. See
SIGNALS.
BRACKET.
1.16 BATTERY