Left Tail Section And Battery Pan: Lightning Models - Buell XB 2010 Service Manual

HOME
LEFT TAIL SECTION AND BATTERY PAN:
LIGHTNING MODELS
DISASSEMBLY
1. Remove seat.
Disconnect negative (-) battery cable first. If positive (+)
cable should contact ground with negative (-) cable con-
nected, the resulting sparks can cause a battery explosion,
which could result in death or serious injury. (00049a)
2. See Figure 2-192. Disconnect battery cables from battery:
negative cable (black) first.
3. Remove battery.
4. See Figure 2-192. Disconnect:
a. Wire harness ground (2) [GRD 2].
b. Rear brake light switch connector (5) [121].
c. ECM connectors (7) [10 & 11] and [164] (on XB12
models).
d. BAS (bank angle sensor) connector (9) [134].
e. Right turn signal connector (10) [19].
f. Left turn signal connector (11) [18].
g. License plate lamp connector (12) [45].
h. Tail light connectors (13) [93].
i. Ground terminals on right side tail section (6) [GRD1]
& [GRD 3].
5. Remove the rear shock absorber reservoir. See
2.23 REAR SHOCK ABSORBER.
6. Cut cable strap attaching BAS wire harness to seat latch
cable.
2-146 2010 XB Service: Chassis
7. See Figure 2-192. Remove fuse block and relay center
from support bracket.
8. Move rear main harness and shock absorber reservoir to
right side of vehicle.
9. Remove left side passenger footrest support assembly.
See 2.34 FOOTPEG, HEEL GUARD AND MOUNT:
FIREBOLT AND LIGHTNING
10. See Figure 2-192. Remove the following fasteners:
a. Left front trunk pan to left side tail section (14).
b. Left rear tail section to center tail section (15).
c. Left tail section to main frame/fuel tank assembly.
d. Left tail section to battery tray.
11. Remove left tail section from vehicle.
NOTE
In order to remove trunk pan it will be necessary to remove the
following fasteners and components.
12. Remove two fasteners securing trunk pan to center tail
section.
13. See Figure 2-192. Remove fastener securing right front
trunk pan to right side tail section.
14. Remove right side passenger footrest support assembly.
See 2.34 FOOTPEG, HEEL GUARD AND MOUNT:
FIREBOLT AND LIGHTNING
15. Slide trunk pan with battery pan, seat latch, bank angle
sensor, rear shock reservoir mounting bracket and ECM
out left side of vehicle.
16. Remove remaining components on trunk pan as needed.
2.40
MODELS.
MODELS.