Buell XB 2010 Service Manual page 563

HOME
7. Install four cable straps securing auxiliary harness and
main harness to frame.
8. Install ignition coil. See 4.6 IGNITION
NOTES
Make sure the spark plug wires are fully seated on coil
towers before proceeding.
Do not force the fan into position or attempt to use
fasteners to draw fan into position as damage to the fan
housing may occur. Wire bundle positioned correctly will
allow fan to be fully seated without force.
9. Install fan. See 4.11 COOLING
10. Install rear shock absorber assembly and reservoir. See
2.23 REAR SHOCK ABSORBER.
11. Lower rear wheel to ground and remove scissor jack from
under muffler.
12. Install right side engine shroud air scoop. See
SCOOPS.
13. Install Siren to V-bracket if previously installed.
NOTE
When installing the left side air scoop it is necessary to make
sure that the voltage regulator and alternator wiring harnesses
are not trapped between the air scoop and cylinder head.
14. Install left side air scoop. See
15. Install windscreen and windshield. See
AND WINDSCREEN: LIGHTNING AND ULYSSES
MODELS.
COIL.
FAN.
2.49 AIR
2.49 AIR SCOOPS.
2.48 WINDSHIELD
16. Install electronic control module. See
CONTROL MODULE (ECM).
17. Install battery.
a. Connect battery positive cable from battery positive
(+) terminal.
b. Install terminal cover boot on battery positive cable
(red).
c. Connect battery negative cable (black) to battery
negative (-) terminal.
NOTE
In order to perform the next step in this procedure, you need
to make sure that you have a fully charged battery in order to
energize the Lighting/Siren Control Module.
18. Verify operation of all emergency components.
19. Install air cleaner assembly. See
ASSEMBLY.
After installing seat, pull upward on seat to be sure it is
locked in position. While riding, a loose seat can shift
causing loss of control, which could result in death or
serious injury. (00070b)
20. Install seat.
2010 XB Service: Electrical 6-89
4.4 ELECTRONIC
4.3 AIR CLEANER