Footpeg, Heel Guard And Mount - Buell 2007 FIREBOLT Service Manual

HOME

FOOTPEG, HEEL GUARD AND MOUNT

RIDER
Remove Wear Peg
1. See Figure 2-110. Remove wear peg from end of footpeg
assembly.
Remove Footpeg
1. See Figure 2-110. Remove clip (5).
2. Remove footpeg pin (9).
3. Remove footpeg (8).
Remove Heel Guard
1. See Figure 2-110. Remove heel guard fasteners (4).
2. Remove heel guard (3).
Remove Mount
1. See Figure 2-110. Remove footpeg mount fasteners (2).
2. Remove footpeg mount (1).
Install Mount
1. See Figure 2-110. Position footpeg mount (1).
b0934a2x
2
3
5
6
4
1. Footpeg mount
2. Footpeg mount fasteners
3. Heel guard
4. Heel guard fasteners
5. Clip, footpeg
1
9
8
7
Figure 2-110. Rider Footpeg, Mount and Heel Guard Assembly
2. Install footpeg mount with fasteners (2). Tighten to 132-
144 in-lbs (14.9-16.2 Nm).
Install Heel Guard
1. See Figure 2-110. Position heel guard (3) onto footpeg
mount (1).
NOTE
There is one long fastener which installs on the lower left side
in order to secure the non-California vent clamp.
2. Install heel guard (3) with fasteners (4). Tighten to 72-
96 in-lbs (8-11 Nm).
Install Footpeg
1. See Figure 2-110. Position spring (6) in footpeg (8).
2. Position footpeg (8) and spring in footpeg mount (1).
3. Install footpeg pin (9).
4. Install clip (5).
Install Wear Peg
1. See Figure 2-110. Apply LOCTITE 271 (red) and tighten
to 36-48 in-lbs (4-5 Nm).
6. Spring
7. Wear peg
8. Footpeg
9. Pin
2007 Buell Firebolt: Chassis
2.29
2-81