Ignition/Headlamp Key Switch - Buell XB 2010 Service Manual

HOME

IGNITION/HEADLAMP KEY SWITCH

GENERAL
The automatic-on headlamp feature provides increased
visibility of the rider to other motorists. Be sure headlamp
is on at all times. Poor visibility of rider to other motorists
can result in death or serious injury. (00030b)
Switch positions are explained in
NOTE
The key locks the ignition system and is removable in both the
LOCK and P positions. The P position is located counterclock-
wise from the LOCK position and allows the rider to remove
the key while leaving the lights on. When the key is placed in
the P position, several indicator markers are or can be activ-
ated. Refer to Table 6-10.
sm00359
2
3
4
P
5
1. ON position
2. OFF position
3. PUSH DETENT
4. LOCK position
5. PARKING LIGHT position
Figure 6-1. Ignition/Headlight Key Switch
Table 6-9. Ignition Key Switch Positions
LABEL IGNITION
OFF Off
P Off
ON On
LOCK Off
Table 6-9.
1
LAMPS REMOVE
KEY
Off Yes
See note and Yes
Table 6-10.
No
Off Yes
Table 6-10. Indicator Markers
ITEM
Headlight position marker lamps
(European models only)
Headlight high beam
Headlight low beam
Instrument module illumination lamps
Stop lamp
Front and rear turn signals
Horn
Aux power outlets
FIREBOLT
PART NUMBER
FTXR45E SNAP-ON TAMPER-RESISTANT T45
TORX DRIVER
Removal
1. Remove seat.
To prevent accidental vehicle start-up, which could cause
death or serious injury, disconnect negative (-) battery
cable before proceeding. (00048a)
2. Disconnect negative battery cable.
3. Cut cable strap holding ignition switch, fuse block and right
handlebar switch wires.
4. Disconnect ignition switch connector [33].
5. See Figure 6-2. Remove cable straps attached to the
upper fork clamp.
6. Remove air cleaner cover. See
7. See Figure 6-3. Remove steering stem pinch fastener (2).
8. Remove upper fork clamp pinch fasteners (1).
9. Hold or brace the lower fork clamp and remove steering
stem capnut (3).
10. Remove the upper fork clamp (4) from forks.
11. See Figure 6-5. Use SNAP-ON TAMPER-RESISTANT
T45 TORX DRIVER (Part No. FTXR45E) to remove igni-
tion switch fasteners (3) securing ignition switch (4) to
upper fork clamp. Slide ignition switch out of upper fork
clamp.
2010 XB Service: Electrical 6-5
6.3
P ON
On On
Off Can be
activated
Off On
Off On
Off Can be
activated
Can be activated
Cannot be Can be
activated activated
Off On
TOOL NAME
2.38 INTAKE COVER.