Transmission Right Case Bearings - Buell XB 2010 Service Manual

HOME

TRANSMISSION RIGHT CASE BEARINGS

REMOVAL
PART NUMBER
HD-95760-69A BUSHING AND BEARING PULLER
HD-95765-69A 1/2 IN. COLLET
1. Split crankcases in half. See
FOR TRANSMISSION REMOVAL.
2. Remove transmission
5.10 TRANSMISSION DISASSEMBLY.
Countershaft Needle Bearing
See Figure 5-82. From inside transmission case use a common
bearing puller to remove countershaft bearing (11) from
crankcase bore.
Shifter Drum Bushing
1. The shifter drum bushing (12) is a press fit in the right
crankcase half. Inspect the bushing against the corres-
ponding end of the shifter drum for proper fit and wear.
2. If bushing is to be replaced, use BUSHING AND BEARING
PULLER (Part No. HD-95760-69A) with 1/2 IN.
COLLET (Part No. HD-95765-69A) to remove bushing
from crankcase bore.
TOOL NAME
5.9 CASE DISASSEMBLY
as an assembly. See
INSTALLATION
PART NUMBER
A157-8 SNAP-ON BUSHING DRIVER 1/2-INCH
ADAPTER
A157C SNAP-ON BUSHING DRIVER SET
Countershaft Needle Bearing
1. Find a suitable bearing driver 1-1/4 in. (31.75 mm) in dia-
meter.
2. See Figure 5-82. From the outside of the case place the
closed end needle bearing (11) open end first next to the
bearing bore. Hold the driver squarely against the closed
end of the bearing and tap the bearing into place. The
bearing is properly positioned when it is driven flush or
0.030 in. (0.762 mm) below the outside surface of the
case.
3. Lubricate bearing with GENUINE HARLEY-DAVIDSON
FORMULA+ TRANSMISSION AND PRIMARY CHAIN-
CASE LUBRICANT (Part No. 99851-05).
Shifter Drum Bushing
1. See Figure 5-82. Using SNAP-ON BUSHING DRIVER
SET (Part No. A157C) with a SNAP-ON BUSHING
DRIVER 1/2-INCH ADAPTER (Part No. A157-8), install
new bushing (12).
2. Lubricate bushing with GENUINE HARLEY-DAVIDSON
FORMULA+ TRANSMISSION AND PRIMARY CHAIN-
CASE LUBRICANT (Part No. 99851-05).
2010 XB Service: Drive/Transmission 5-47
5.13
TOOL NAME