Installation: Ulysses - Buell XB 2010 Service Manual

HOME
Connect positive (+) battery cable first. If positive (+) cable
should contact ground with negative (-) cable connected,
the resulting sparks can cause a battery explosion, which
could result in death or serious injury. (00068a)
6. Install and connect battery. See
ANCE.
After installing seat, pull upward on seat to be sure it is
locked in position. While riding, a loose seat can shift
causing loss of control, which could result in death or
serious injury. (00070b)
7. Install seat.
sm00857a
Figure 2-147. Rear Shock Absorber Remote Reservoir
Clamp (XB12S Shown) and Compression Dial

INSTALLATION: ULYSSES

1. See 2.23 REAR SHOCK ABSORBER
assembly, preload adjuster assembly and remote reservoir
into position. SeeFigure
2. Install the lower shock bolt with nut and thick washer and
tighten nut to 15-17 ft-lbs (20.3-23 Nm).
1.16 BATTERY MAINTEN-
Lower rear shock
2-143.
3. Install upper shock bolt and tighten to 48-52 ft-lbs (65.1-
70.5 Nm).
4. Install the two fasteners holding the preload adjuster in
place and tighten to 36-60in-lbs (4.1-6.8 Nm).
5. Install rear shock reservoir clamp (7) and fastener (6) and
tighten clamp fastener to 80-88 in-lbs (9.0-9.9 Nm).
6. Install ECM. See 4.4 ELECTRONIC CONTROL MODULE
(ECM).
7. Install fan shroud. See 2.49 AIR SCOOPS
8. Lower scissor jack and remove from under vehicle.
Connect positive (+) battery cable first. If positive (+) cable
should contact ground with negative (-) cable connected,
the resulting sparks can cause a battery explosion, which
could result in death or serious injury. (00068a)
9. Install and connect battery. See
ANCE.
After installing seat, pull upward on seat to be sure it is
locked in position. While riding, a loose seat can shift
causing loss of control, which could result in death or
serious injury. (00070b)
10. Install seat.
sm00595
Figure 2-148. Rear Shock Absorber Preload Adjuster Knob:
Ulysses
2010 XB Service: Chassis 2-109
1.16 BATTERY MAINTEN-