Buell XB 2010 Service Manual page 325

HOME
sm00165
Figure 3-81. Connecting Rod Clamping Tool
sm00166
4
2
1
3
1. Hex cylinder
2. Threaded rod
3. Flat washer
4. Bearing
5. Driver (2 way)
6. Receiver cup
7. Nut
Figure 3-82. Piston Pin Bushing Tool (Part No.
HD-95970-32D)
6
7
5
sm03828
1
1. Remover side of driver
2. Receiver cup
Figure 3-83. Removing Wrist Pin Bushing
sm03829
Figure 3-84. Installer Side of Driver
ASSEMBLY/INSTALLATION
PART NUMBER
HD-34623C PISTON PIN RETAINING RING
INSTALLER
HD-42322 PISTON SUPPORT PLATE
HD-96333-51E PISTON RING COMPRESSOR
1. See Figure 3-85. Place PISTON SUPPORT PLATE (Part
No. HD-42322) in position as shown.
2. Install piston assembly over connecting rod.
NOTE
See Figure 3-86. Piston must be installed with the arrows
pointing towards the front of the engine.
3. Liberally lube piston pin with clean engine oil and install
piston pin.
NOTE
Always use new retaining ring. Make sure retaining ring groove
is clean and that ring seats firmly in groove. If it does not, dis-
card the ring. Never install a used retaining ring or a new one
2
TOOL NAME
2010 XB Service: Engine 3-57