Buell XB 2010 Service Manual page 385

HOME
sm00864
4
1
4
1
1. Bank angle sensor
2. Fuse block and electrical relays
3. Seat latch bracket
4. BAS fasteners
Figure 4-25. Bank Angle Sensor: Lightning (Top), XB12Ss
(Bottom)
3
2
3
2
Ulysses
1. See Figure 4-25. Install bank angle sensor to mounting
tab with fasteners and tighten to 12-36 in-lbs (1.4-4 Nm).
2. Install BAS bracket to seat latch bracket. Tighten fasteners
to 72-96 in-lbs (8-10.8 Nm).
3. Install bank angle sensor connector [134].
4. Connect negative battery cable and tighten fastener to
60-70 in-lbs (6.8-7.9 Nm).
After installing seat, pull upward on seat to be sure it is
locked in position. While riding, a loose seat can shift
causing loss of control, which could result in death or
serious injury. (00070b)
5. Install seat.
2010 XB Service: Fuel System 4-19