Footpeg, Heel Guard And Mount - Buell 2003XB9S Service Manual

HOME

FOOTPEG, HEEL GUARD AND MOUNT

RIDER
Remove Wear Peg
1. See Figure 2-101. Remove wear peg from end of footpeg
assembly.
Remove Footpeg
1. See Figure 2-101. Remove clip (5).
2. Remove footpeg pin (9).
3. Remove footpeg (8).
Remove Heel Guard
1. See Figure 2-101. Remove heel guard fasteners (4).
2. Remove heel guard (3).
Remove Mount
1. See Figure 2-101. Remove footpeg mount fasteners (2).
2. Remove footpeg mount (1).
b0934a2x
2
3
5
4
1. Footpeg mount
2. Footpeg mount fasteners
3. Heel guard
4. Heel guard fasteners
5. Clip, footpeg
1
9
6
8
7
Figure 2-101. Rider Footpeg, Mount and Heel Guard Assembly
Install Mount
1. See Figure 2-101. Position footpeg mount (1).
2. Install footpeg mount with fasteners (2). Tighten to 108-
132 in-lbs (12-15 Nm).
Install Heel Guard
1. See Figure 2-101. Position heel guard (3) onto footpeg
mount (1).
2. Install heel guard (3) with fasteners (4). Tighten to 72-
96 in-lbs (8-11 Nm).
Install Footpeg
1. See Figure 2-101. Install clip (5).
2. Position footpeg (8) on to footpeg mount (1).
3. Install footpeg pin (9).
Install Wear Peg
1. See Figure 2-101. Apply Loctite 272 (Red) and tighten to
36-48 in-lbs (4.1-5.4 Nm).
6. Spring
7. Wear peg
8. Footpeg
9. Pin
2003 Buell XB9S: Chassis
2.30
2-75