Buell XB 2010 Service Manual page 284

HOME
22. Disconnect clutch cable.
a. Slide clutch cable adjuster boot (2) up to access clutch
adjuster.
b. Loosen clutch adjuster to release tension from hand
lever.
c. Remove clutch cable ferrule from hand lever.
NOTE
Anytime front tie-bar is removed, it must first be removed from
the "V" bracket and then the engine. When installing the tie-
bar, first mount to engine and then to "V" bracket in order to
prevent damage to threaded area of crankcase.
sm04207
1
1. Alternator connector
2. Voltage regulator connector
Figure 3-6. Alternator and Voltage Regulator Connectors
sm03858
1
1. Speedometer sensor [65]
2. Positive battery cable at starter
3. Starter solenoid [128]
29. See 3.12 OIL LINE FITTINGS. Remove all oil lines
(including lines to oil cooler).
3-16 2010 XB Service: Engine
2
3
2
4
5
Figure 3-7. Electrical Connections on Right Side of Motorcycle
23. See Figure 3-9. Remove front "V" bracket with oil cooler
from main frame.
a. Disconnect alternator connector [46] (1) and voltage
regulator connector [77] (2) in order to remove the
"V" bracket.
b. Remove the two cable straps securing the CKP har-
ness to the "V" bracket on the left side of the engine.
c. Disconnect CKP.
d. Disconnect oil cooler lines at oil cooler.
e. Remove front tie-bar (7) from "V" bracket.
f. Remove front tie-bar (7) from engine.
g. Unbolt "V" bracket from main frame and remove "V"
bracket.
24. Remove center tie-bar (13) from engine.
25. Remove rear tie bar (21) from frame.
26. Remove the cable strap securing the oil pressure wire,
neutral safety wire and muffler actuator cable in a bundle
on the right side of the motorcycle just behind the oil pump
body.
27. Remove cable strap securing the positive cable from
starter and the main harness to the transmission vent line.
28. See Figure 3-7. Disconnect electrical components:
a. Neutral switch [131] (4).
b. Speedometer sensor [65] (1) (remove cable strap).
c. Positive battery cable at starter (2).
d. Starter solenoid [128] (3).
e. Oil pressure switch [120] (6).
6
4. Neutral switch [131] connection
5. Interactive exhaust cable
6. Oil pressure switch [120]