Buell XB 2010 Service Manual page 234

HOME
sm00666b
Figure 2-198. Internal Fasteners/Right Side Tail Section
14. See Figure 2-197 and Figure
securing right tail section to main frame/fuel tank assembly.
15. Remove right tail section.
CLEANING
NOTE
Do not use wheel care products or other compounds developed
specifically for cleaning and polishing powdercoat. These
cleaners could potentially damage the tail section finish.
The cast aluminum tail section has a powder coat. Because
the surface is not bare polished aluminum, it must be cleaned
using only mild soap and warm water. After washing, always
dry the surface using a clean, soft cloth.
ASSEMBLY
1. Install left and/or right tail section onto vehicle.
a. Apply LOCTITE 271 (red) and install fasteners
attaching left and/or right tail section to main
frame/fuel tank assembly and tighten to 21-23 ft-lbs
(28.5-31.2 Nm).
b. Install fastener attaching left front trunk pan to left
side tail section and tighten to 12-36 in-lbs (1.4-4
Nm).
c. Install fastener securing right front trunk pan to right
side tail section and tighten to 12-36 in-lbs (1.4-4
Nm).
d. Install fasteners securing rear trunk pan to tail section
and tighten to 48-72 in-lbs (5.4-8.1 Nm).
2-154 2010 XB Service: Chassis
2-198. Remove fasteners
2. Install shock reservoir, retainer and fastener. Tighten
fastener to 80-88 in-lbs (9.0-9.9 Nm).
3. Install two fasteners securing the preload adjuster to the
trunk pan and tighten to 36-60 in-lbs (4-6.8 Nm).
4. Install battery pan:
a. Install fasteners securing battery tray to left and right
tail sections and tighten to 72-96 in-lbs (8-10.8 Nm).
b. See Figure 2-194. Install fuse block and relay center
(4).
c. Install main harness and plastic grommet (6) into
battery pan.
d. Connect rear brake light switch connector [121].
For Ulysses models always install a new fastener with a
lock patch in front hole of ECM.
e. Install rear ECM fastener and tighten to 36-60 in-lbs
(4-6.8 Nm).
f. Install new front ECM fastener and tighten to 30-40
in-lbs (3.4-4.5 Nm).
5. Connect ECM connectors (3) [10] and [11].
6. If removed, install center tail loop. See
LOOP: ULYSSES MODELS.
Connect positive (+) battery cable first. If positive (+) cable
should contact ground with negative (-) cable connected,
the resulting sparks can cause a battery explosion, which
could result in death or serious injury. (00068a)
7. Install battery. See 1.16 BATTERY
After installing seat, pull upward on seat to be sure it is
locked in position. While riding, a loose seat can shift
causing loss of control, which could result in death or
serious injury. (00070b)
8. Install seat.
NOTE
2.44 CENTER TAIL
MAINTENANCE.