Installation; Main Drive Gear Ball Bearing - Buell XB 2010 Service Manual

HOME
will be at the prescribed depth from the end of the main
drive gear. Refer to Table
Table 5-8. Outer Needle Bearing Depth
MODEL
All Models
sm00328
2
3
4
1. Press ram
2. Needle bearing installation tool
3. Needle bearing
4. Main drive gear
Figure 5-70. Pressing Inner Needle Bearing Assembly into
Main Drive Gear
sm00329
2
3
4
1. Press ram
2. Needle bearing installation tool
3. Needle bearing
4. Main drive gear
Figure 5-71. Pressing Outer Needle Bearing Assembly into
Main Drive Gear
5-8.
DEPTH
0.285 in. (7.2 mm)
1
1

INSTALLATION

PART NUMBER
B-45847 CROSS PLATE
HD-35316-12 INSTALLER CUP
HD-35316-4A 8 IN. BOLT
HD-35316-7 WASHER
HD-35316-8 BEARING DRIVER
HD-47856-1 INSTALLER
HD-47856-2 PILOT
HD-47856-4 ADAPTER
HD-47856-5 NUT
HD-47856-7 CROWFOOT WRENCH

Main Drive Gear Ball Bearing

1. See Figure 5-72. Place CROSS PLATE (Part No. B-45847)
(1) on right crankcase as shown. Position cross plate so
that roll pins (2) fit into crankcase mating screw holes and
bolt hole (3) in cross plate is centered over crankcase
bearing bore (4).
2. See Figure 5-73. Insert 8 IN. BOLT (Part No. HD-35316-
4A) (2) through cross plate (1) and main drive gear bearing
bore.
3. At outside of case, place main drive gear ball bearing (3),
BEARING DRIVER (Part No. HD-35316-8) (4), bearing
(5), flat washer (6) and nut (7) over end of bolt.
NOTE
Do not continue to tighten nut after ball bearing bottoms against
lip in crankcase bearing bore. Tightening nut too much can
break lip in bearing bore casting.
4. Tighten nut until main drive gear ball bearing bottoms
against lip cast into crankcase bearing bore.
5. Remove main drive gear bearing installer tool.
Wear safety glasses or goggles when removing or
installing retaining rings. Retaining rings can slip from the
pliers and could be propelled with enough force to cause
serious eye injury. (00312a)
NOTE
Use correct retaining ring pliers and correct tips. Verify that
tips are not excessively worn or damaged.
6. See Figure 5-65. At outside of case install new beveled
retaining ring (9) in groove inside bearing bore with
beveled side facing outside of case.
7. Lubricate main drive gear ball bearing with GENUINE
HARLEY-DAVIDSON FORMULA+ TRANSMISSION AND
PRIMARY CHAINCASE LUBRICANT (Part No. 99851-
05).
2010 XB Service: Drive/Transmission 5-43
TOOL NAME