Buell XB 2010 Service Manual page 289

HOME
sm03741
Figure 3-12. Supporting Vehicle for Disassembly
36. See Figure 3-9. Remove front isolator bolt (6). Remove
front isolator assembly fasteners (5).
37. See Figure 3-13. Remove:
a. Rear isolator bolt (1).
b. Swingarm pivot shaft (2).
sm02952a
1
2
1. Rear isolator bolt
2. Swingarm pivot shaft
Figure 3-13. Rear Isolator Bolt and Swingarm Pivot Shaft
38. Cut the cable straps holding transmission vent line and
pull vent line out of frame leaving it attached to engine.
NOTES
See Figure 3-14. On Firebolt models, the transmission
vent line runs up the left side of the frame and exits
beneath the rear brake reservoir and hose.
See Figure 3-15 and Figure
Ulysses models, the transmission vent line runs up the
left side of the frame and exits underneath the left rear
side of the intake cover assembly.
3-16. On Lightning and
sm00730
Figure 3-14. Transmission Vent Line: Firebolt
sm00737
Figure 3-15. Transmission Vent Line: Lightning
is06235
1
Figure 3-16. Trim Transmission Vent Hose
39. Lower engine with scissors lift all the way down.
40. Move the engine assembly from under the main frame to
the right side of the lift.
2010 XB Service: Engine 3-21