Buell XB 2010 Service Manual page 196

HOME
NOTE
Always connect front tie bar to engine mount first.
15. Install front tie bar, p-clamp and clutch cable to front engine
mount and tighten fastener to 25-27 ft-lbs (33.9-36.6 Nm).
16. Connect front tie bar to "V" bracket and tighten fastener
to 25-27 ft-lbs (33.9-36.6 Nm).
17. Adjust clutch cable. See
SION/PRIMARY FLUID.
18. Install chin fairing. See 2.50 CHIN
2-116 2010 XB Service: Chassis
1.9 CLUTCH/TRANSMIS-
FAIRING.
19. Connect negative battery cable to battery terminal.Tighten
fastener to 60-70 in-lbs (6.8-7.9 Nm).
After installing seat, pull upward on seat to be sure it is
locked in position. While riding, a loose seat can shift
causing loss of control, which could result in death or
serious injury. (00070b)
20. Install seat.