Ulysses; Removal And Disassembly; Assembly And Installation - Buell XB 2010 Service Manual

HOME
sm00453
4
3
2
1. Jam nuts with washers (2)
2. Center tail section
3. Screws (2)
4. Lamp lens
5. License plate lamp
Figure 6-69. License Plate Lamp: Lightning

ULYSSES

Removal and Disassembly

1. Remove seat.
2. See Figure 6-70. Remove the cover for the rear wiring (3).
3. Disconnect the two connectors [45] from license plate
lamp harness.
4. Pull the lamp assembly away from license plate bracket
(1) pulling the harness out of the license plate bracket.

Assembly and Installation

1. See Figure 6-70. Install new license plate lamp assembly.
a. Insert license plate lamp wiring harness through hole
and route into the center tail section (2) and the
license plate bracket (4).
b. Attach the two connectors [45] from license plate lamp
to main harness.
c. Attach lamp (3) and wire cover (5) to tail section using
washers and jam nuts (1) and tighten to 12-36 in-lbs
(1.4-4 Nm).
d. See Figure 6-70. Attach front of wire cover by
installing remaining fasteners (6) and tightening to
36-48 in-lbs (4.1-5.4 Nm).
5
1
2. Check lamp for proper operation. If operation fails, reread
procedure and verify that all steps were performed.
a. Turn ignition key switch to ON.
b. Check for license plate lamp illumination.
c. Turn ignition key switch to OFF.
After installing seat, pull upward on seat to be sure it is
locked in position. While riding, a loose seat can shift
causing loss of control, which could result in death or
serious injury. (00070b)
3. Install seat.
sm00450
1
1. Center tail section
2. License plate bracket
3. Cover, rear wiring
Figure 6-70. License Plate Lamp Mounting: Ulysses
2010 XB Service: Electrical 6-59
2
3