Inter-Function Delay - CipherLab 2564MR User Manual

2564MR Barcode Scanner User Guide
2D One-Scan Setup Barcode for connecting with a target device
Exit SPP Master Mode
To stop such re-connection, read "Reset Connection" or "Restore System Defaults" barcode so that the
current connection record (= MAC ID) will be cleared. Then, the scanner will restart itself automatically.
Go through the process in 3.2.3 Connect to Dongle to establish a new WPAN connection.
Reset Connection

2.3.2 INTER-FUNCTION DELAY

By default, the inter-function delay is set to zero. Specify a value, ranging from 0 to 254 in
units of millisecond, to match the computer response time of the keyboard interface. Such
delay time is inserted between every function code (0x01 ~ 0x1F) being transmitted. The
longer the delay time is, the slower the transmission speed will be.
Inter-Function
Delay... (*0~254)
1) Read the barcode above to specify the inter-function delay.
2) Read the "Decimal Value" barcode on page 263 for the desired inter-function delay
(millisecond).
3) Read the "Validate" barcode on the same page to complete this setting.
68
Enter Setup