2564MR Barcode Scanner
1.6.5 AIMING MODE
The scanner will aim at a barcode once the trigger is pressed, and start scanning when the
trigger is pressed again within one second.
The scanning won't stop until (1) a barcode is decoded, and (2) the pre-set timeout
expires.
Aiming Timeout
You can limit the aiming time interval (1~15). By default, the scanner time-out is set to 1 second.
1.
Read the barcode above to specify the time interval before aiming ends. (It is set to 1 by default.)
2.
Read the
"Decimal
automatically shut down after idleness of 10 seconds.
3.
Read the "Validate" barcode on the same page to complete this setting.
1.6.6 MULTI-BARCODE MODE
The scanner will be scanning as long as the trigger is held down, capable of decoding one
single barcode, as well as multiple unique barcodes one at a time. While decoding a bunch
of unique barcodes, if a barcode is decoded twice, its subsequent decoding will be ignored
and the scanner is expecting another unique barcode.
For 1564 to decode multiple unique barcodes, the maximum output data length of all the
barcodes is 10 KB after configuration. When the output length exceeds 10 KB,
Multi-Barcode Mode will not take effect.
The scanning won't stop until you release the trigger.
Note: (1) A barcode is considered unique when its Code Type or data is different from
others.
(2) Multi-Barcode Mode has nothing to do with the
1.6.7 PRESENTATION MODE
40
User Guide
Value" barcode on page 263. For example, read "1" and "0" for the scanner to
Aiming Mode
Aiming Time-out
after 1~15 sec.
(*1)
Multi-Barcode Mode
Multi-Barcode
Enter Setup
Editor.