Table of Contents
Advertisement
5.4 CODE ID
Up to two characters for Code ID can be configured for each symbology. To make the Code
ID configuration easier, the scanner provides five pre-defined Code ID sets that you can
select one and make necessary changes on it.
If "BT HID", "USB HID" or "Keyboard Wedge" is configured for interface,
and
Key Status
Status when "Normal Key" is selected for Key Type.
Key Type
Scan Code
Only 1 scan code value is allowed.
Normal Key
Up to 2 character strings are allowed.
Note: "]C1" is the Code ID of GS1-128 (EAN-128) barcodes; "]e0" is the default Code ID of
GS1 DataBar (RSS) barcodes.
5.4.1 SELECT PRE-DEFINED CODE ID
will then become applicable. You may decide whether or not to apply Key
Chapter 5
Key Status
N/A
Add Shift
Add Left Ctrl
Add Left Alt
Add Right Ctrl
Add Right Alt
Refer to Keyboard Wedge Table.
Apply Code ID Set 1
Apply Code ID Set 2
Apply Code ID Set 3
Apply Code ID Set 4
Apply Code ID Set 5
Update
Defining Output Format
Key Type
189
Advertisement
Table of Contents
