Removal Of Special Character - CipherLab 2564MR User Manual

Warning: When you disable the Multi-Barcode Editor later, the scan mode remains
unchanged. If Laser mode is not desired, proceed to select a scan mode best
suits your application.

5.7 REMOVAL OF SPECIAL CHARACTER

You can only specify 1 character, but it will remove every matching character encountered
from the starting position of barcode data until a different character is met. For example, if
it is configured to remove the character "0" (hex value is "30"), one or more zeros will be
stripped off the barcode data "012345" and "00012345". However, for barcode data
"010333", only the first zero will be stripped off.
1) Read the barcode above to remove the specified character.
2) Read the "Hexadecimal
example, read "3" and "0" for the scanner to remove the character "0".
3) Read the "Validate" barcode to complete this setting.
Value" barcode on page 264 for the desired character string. For
Chapter 5 Defining Output Format
*Ignore Output
Sequence
Enforce Output
Sequence
Apply Output
Sequence
Remove Special
Character
Update
207