CipherLab 2564MR User Manual page 273

Appendix IV
Note: When using BT HID, some device driver may not support pre-defined PIN code for
authentication. In this case, make sure you have the scanner set to "No PIN or use
random PIN" before pairing. While pairing, the host PIN code will be displayed on the
computer screen.
Use Random PIN
When the target device is set to use a random PIN for authentication, wait until the random PIN is
displayed on the target device while pairing, and then input the matching PIN code on the scanner.
Note: Follow the steps below to enter the matching PIN on the scanner. There is no need to
enter the configuration mode!
1. Read one of the barcodes to specify the PIN code, in decimal or hexadecimal.
2. Read the "Decimal
for the desired digits or character string.
Read the "Clear PIN Code" barcode first if you need to re-input the PIN.
3. Read the "Validate" barcode to complete this setting.
Reject Random PIN Request
When the random PIN is displayed on the target device while pairing, you can reject the PIN request
by having the scanner read the "Validate" barcode.
错误!使用"开始"选项卡将 標題 1 应用于要在此处显示的文字。
Value" barcode on page 263 or the
Update
Enter PIN in
Hexadecimal...
Enter PIN in
Decimal...
"Hexadecimal Value" barcode on page 264
Clear PIN Code
Abort
267