Table of Contents
Advertisement
2564MR Barcode Scanner
For the scanner to keep the customized settings as user defaults, you must have it read the
"Save as User Defaults" barcode. This is a normal setup barcode, and the scanner will
respond with two beeps (low-high tone).
After reading the "Update" barcode, the current settings will be saved as user defaults.
RESTORE USER DEFAULTS
For the scanner to restore the user defaults, which you have saved earlier, you must have
it read the "Restore User Defaults" barcode. This is a normal setup barcode, and the scanner
will respond with two beeps (low-high tone).
After reading the "Update" barcode, all the parameters of the scanner will return to their
customized values.
RESTORE SYSTEM DEFAULTS
For the scanner to restore the factory defaults, you must have it read the "Restore System
Defaults" barcode. This is a normal setup barcode, and the scanner will respond with two
beeps (low-high tone). For the cradle to restore factory defaults, refer to
Barcodes & Serial
Commands.
After reading the "Update" barcode, all the parameters of the scanner will return to their
default values. The current connection record will be cleared as well.
Note: The system default value (if there is) for each setting is indicated by an asterisk "*".
READ A SETUP BARCODE
CONFIGURE PARAMETERS
For most of the scanner parameters, only one read is required to set them to new values.
The scanner will respond with two beeps (low-high tone) when each parameter is set
successfully.
14
User Guide
Save as User
Defaults
Restore User
Defaults
Restore System
Defaults
Enter Setup
BT Cradle Setup
Advertisement
Table of Contents
