Table of Contents
Advertisement
2564MR Barcode Scanner
2.2 BT SPP SLAVE
For BT SPP Slave, refer to Chapter 3 – Setting up a WPAN Connection for related connection
settings.
2.2.1 ACTIVATE BT SPP SLAVE MODE
Scan this barcode to have the scanner get into SPP Slave Mode.
2.2.2 INTER-FUNCTION DELAY
By default, the inter-function delay is set to zero. Specify a value, ranging from 0 to 254 in
units of millisecond, to match the computer response time of the keyboard interface. Such
delay time is inserted between every function code (0x01 ~ 0x1F) being transmitted. The
longer the delay time is, the slower the transmission speed will be.
1) Read the barcode above to specify the inter-function delay.
2) Read the
"Decimal
(millisecond).
3) Read the "Validate" barcode on the same page to complete this setting.
2.2.3 ACK/NAK TIMEOUT
By default, the scanner sends data to the host without waiting for an ACK/NAK response
before sending more data. Specify a value, ranging from 1 to 99 in units of 0.1 second. If no
response within the specified period of time, the scanner will attempt to send the same data
two more times. If all three attempts fail without any notification, data loss will occur.
1) Read the barcode above to specify the time interval for the scanner to send data and
wait for a response from the host.
64
User Guide
Value" barcode on page 263 for the desired inter-function delay
Auto reconnect off
Activate BT SPP,
Slave Mode
Inter-Function
Delay... (*0~254)
ACK/NAK Time-out
after ... (*0~99)
Enter Setup
Advertisement
Table of Contents
