Character Substitution; Select A Set For Character Substitution - CipherLab 2564MR User Manual

2564MR Barcode Scanner

5.2 CHARACTER SUBSTITUTION

Character substitution is performed on every occurrence of the first character specified. If
only one character is specified, every occurrence of that character in the barcode will be
taken away.
The first character will be replaced by the second character(s).

Up to three sets of character substitution can be configured.

If "BT HID", "USB HID" or "Keyboard Wedge" is configured for interface,

and Key Status
Status when "Normal Key" is selected for Key Type.
Key Type
Scan Code Only 1 scan code value is allowed. Refer
to 5.2.1 Select a Set for Character
Substitution.
Normal Key Up to 3 character strings are allowed.
Note: The character substitution is performed only on the barcode itself and before the
processing of editing formats. It is not applicable to the Prefix/Suffix Code, Code ID,
Length Code, or any Additional Field.

5.2.1 SELECT A SET FOR CHARACTER SUBSTITUTION

176
User Guide
will then become applicable. You may decide whether or not to apply Key
Key Status
N/A
 Add Shift

Add Left Ctrl
 Add Left Alt
 Add Right Ctrl
 Add Right Alt
Refer to Keyboard Wedge Table.
Configure Set 1
Enter Setup
Key Type