CipherLab 2564MR User Manual page 37

1.1.2.2 AUTO POWER OFF
For the scanner to save power, further to setting up "Power-Saving" mode, you may also
need to enable "Auto Power Off", which deals with a time for the scanner to automatically
power off after power-on. Make the configuration that best suits your application while
noting the following points:
Auto Power Off: 1~254 minutes configurable. 0= Disable.

1. By default, the scanner automatically shuts down 10 minutes after power-on.
2. If Auto Power Off isn't desired, set the parameter to 0 to disable it.
3. When the scan mode is set to Test Mode, you need to enable "Auto Power Off
Ignoring Scan Mode" in addition to enabling "Auto Power Off". See the following
section 1.1.2.3 Auto Power Off Ignoring Scan Mode.
Note: When the scanner is set to any scan mode other than Test Mode, you can ignore
"Auto Power Off Ignoring Scan Mode".
1) Read the barcode above to enable the scanner to automatically turn off at a specified
time after power-on.
2) Assign the auto power off time by reading the
example, read "1" and "5" for the scanner to automatically turn off after idleness of 15
minutes.
3) Read the "Validate" barcode on the same page to complete this setting.
Note: "Auto Power Off" will not take effect when the scanner is in the configuration mode.
1.1.2.3 AUTO POWER OFF IGNORING SCAN MODE
This mode is intended only for Test Mode. To force a scanner that is set to Test Mode to

automatically power off to save power, you need the following settings:
1. Enable "Auto Power Off" and set a time for the scanner to automatically power off
after power-on. See the foregoing section
2. Enable "Auto Power Off Ignoring Scan Mode" by reading the barcode below:
Chapter 1 Understanding the Barcode Scanner
Auto Power Off after
0~254 min. (*10)
"Decimal Value" barcode on page 263. For
1.1.2.2 Auto Power Off
Update
25