Configure Related Settings; Connecting Via Bluetooth ® Dongle; Change Interface - CipherLab 2564MR User Manual

2564MR Barcode Scanner

3.1.3 CONFIGURE RELATED SETTINGS

Sniff Mode (Power-saving)
By default, this feature is enabled, meaning the scanner will listen to the wireless network at a
reduced rate.
3.2 CONNECTING VIA BLUETOOTH

3.2.1 CHANGE INTERFACE

Below is the procedure to configure the scanner before establishing a WPAN connection via
®
Bluetooth dongle.
1) Have the scanner read the "Enter Setup" barcode to enter the configuration mode.
2) Have the scanner read the desired interface barcode –
"Activate BT HID & Select Keyboard Type"

"Activate BT SPP Slave Mode"

"Activate BT SPP Master Mode"

3) Have the scanner read the barcodes related to WPAN settings, such as Device Name
Broadcasting, Authentication & PIN Code, etc.
4) Have the scanner read the "Update" barcode to exit the configuration mode.
5) The scanner will stay active for a specified period of time (2 minutes by default) waiting
for a connection request from the host (SPP Slave Mode) or trying to connect to the host
(HID or SPP Master Mode). Its CPU is running at full speed, and the LED is flashing blue
(On/Off ratio 0.5 s: 0.5 s).
Once connected, when getting out of range, the scanner will respond with three short beeps
(tone descending from high to low).
102
User Guide
®
DONGLE
*Enable
Disable
Enter Setup