CipherLab 2564MR User Manual page 112

If you want to change the interface cable of the cradle, use one of the scanners to configure
the interface-related settings and it will pass the new settings to the cradle, which will then
initialize and pass the settings to any other connected scanners.
1) Have the scanner read the "Set Connection" and "Serial Number" labels at the back of
the cradle.
2) Within two minutes, connect the interface cable between the cradle and your computer.
For USB Virtual COM, you may need to install its driver first!
3) The scanners will connect to your computer via the cradle.
4) Have one scanner read the "Enter Setup" barcode to enter the configuration mode.
5) Have the scanner read the desired interface barcode and configure its related settings –
"Activate Keyboard Wedge & Select Keyboard Type"

"Activate RS-232"

"Activate USB HID & Select Keyboard Type"

"Activate USB Virtual COM"

6) Have the scanner read the "Update" barcode to exit the configuration mode.
7) After the scanner resumes connection with the cradle, it will pass the interface-related
settings to the cradle.
8) Upon receipt of the new settings, the cradle will initialize itself.
9) Updated with new settings, the cradle will pass the settings to other connected
scanners.
Chapter 3 Setting up a WPAN Connection
Update
101