5
CryoBay Monitor
CryoBay Controls - Loading Files
72
File allows the user to load configuration and calibration
files to the CryoBay and the temperature controller, as seen
in
Figure
30. Files may only be loaded when the cryogenic
system is in the Idle state.
Set the cryogenic system into the IDEL state.
1
Load the CryoBay Control files from one of the following
2
locations:
•
VnmrJ: The files are located in:
/vnmr/cryo/config/temperaturecontroller/
/vnmr/cryo/config/cryobay/
/vnmr/cryo/probecal
or
/user'sdirectory/vnmrsys/cryo/config/
temperaturecontroller/
/user'sdirectory/vnmrsys/cryo/config/
cryobay/
/user'sdirectory/vnmrsys/cryo/probecal/
•
Stand- Alone Computer: The files are located in:
C:\CryoControls\cryo\config\
temperaturecontroller\
C:\CryoControls\cryo\config\cryobay\
C:\CryoControls\cryo\probecal\
Cryogenic Systems Operation