Cables For The Sgm7G Servomotors; System Configurations - YASKAWA E Series Product Manual

9.3 Cables for the SGM7G Servomotors

9.3.1 System Configurations

9.3

Cables for the SGM7G Servomotors

9.3.1

System Configurations

The cables shown below are required to connect a Servomotor to a SERVOPACK.
Encoder Cable of 20 m or Less
Servomotor
Main Circuit Cable
Servomotor
Note: 1. Cables with connectors on both ends that are compliant with an IP67 protective structure and European
2. If the cable length exceeds 20 m, be sure to use a Relay Encoder Cable.
3. If you use a Servomotor Main Circuit Cable that exceeds 20 m, the intermittent duty zone in the torque-
4. Refer to the following manual for the following information.
9-16
SERVOPACK
C
N
6
Encoder Cable
Battery Case
(Required when an
absolute encoder is used.)
Safety Standards are not available from Yaskawa for the SGM7G Servomotors. You must make such a
cable yourself. Use the Connectors specified by Yaskawa for these Servomotors. (These Connectors are
compliant with the standards.) Yaskawa does not specify what wiring materials to use.
motor speed characteristics will become smaller because the voltage drop increases.
• Cable dimensional drawings and cable connection specifications
• Order numbers and specifications of individual connectors for cables
• Order numbers and specifications for wiring materials
Σ
-7-Series AC Servo Drive Peripheral Device Selection Manual (Manual No.: SIEP S800001 32)
Encoder Cable of 30 m to 50 m (Relay Cable)
C
N
6
SERVOPACK
Servomotor
Main Circuit Cable
Servomotor
Relay Encoder Cable
Cable with a Battery Case
(Required when an
absolute encoder is used.)
Cable with Connectors
on Both Ends
Encoder-end Cable