nord NORDAC FLEX SK 200E Series User Manual page 205

Pos : 550 /Anleitungen/El ektr onik /FU und Starter/5. Par ameter/Par ameter auflistung (P000 ...)/P500- P599/Param eter P553 – PLC Sollw erte [SK 1x 0E, SK 2x xE, SK 2xx E-FDS] @ 12\m od_1467294577806_14638.docx @ 335640 @ @ 1
P553
[-01]
PLC set values
...
(PLC setpoints)
[-05]
0 ... 36 The PLC setpoints are assigned with a function in this parameter. The settings only apply for
main setpoints and with active PLC actuation ((P350) = "On") and ((P351) = "0" or "1").
all = { 0 }
[-01] = Bus setpoint 1
Possible values which can be set:
10 = PI suprvsd. cur. freq.
11 = Torque current limit (limiting)
12 = Torque current switch-off limit
13 = Current limit (limiting)
14 = Current switch-off limit
15 = Ramp time
16 = Pre-tension torque
Pos : 551 /Allgem ein/Allgem eingültig e Module/---------Seitenumbr uc h k ompakt --------- @ 13\m od_1476369695906_0.doc x @ 2265496 @ @ 1
BU 0200 en-US-4920
0 = Off
1 = Setpoint frequency
2 = Frequency addition
3 = Frequency subtraction
4 = Minimum frequency
5 = Maximum frequency
6 = Current value process ctrl
7 = Nom. val. process ctrl.
8 = PID current freq.
9 = PI ltd. current freq.
5 Parameter
S
... [-05] = Bus setpoint 5
17 = Multiplication
18 = Curve control
19 = Servo-mode torque
20 = BusIO In Bits 0-7
21 = Setpoint pos. LowWord
22 = Setpoint pos. HighWord
23 = Setpoint pos. Inc. LowWword
24 = Setpoint pos. Inc. HighWord
25 = Ratio gearing
26 = ... 30: reserved
31 = Digital output IOE
32 = Analog output IOE
33 = Setval. torque p. reg.
34 = d-corr. F process
35 = d-corr. Torque
36 = d-corr. F+Torque
P
205