Table of Contents
Advertisement
Install the SPM
2.
Lower the side of the SPM with the Align Tab sticker at an angle onto the SPM
support on the motherboard (panel 1).
3.
Press the SPM straight down until it is fully seated in its socket (panel 2).
Ensure that the notched tab at the other end of the SPM is held in place.
4.
Return the server to an operational condition.
a.
Install the top cover.
See
b.
Return the server to the normal operating position.
See
Reconnect the power cords to the power supplies.
c.
See
Prior to powering on the server, connect a terminal or a terminal emulator (PC or
5.
workstation) to the SER MGT port.
If the replacement SPM detects that the SPM firmware is not compatible with the existing host
firmware, further action will be suspended and the following message will be displayed:
Unrecognized Chassis: This module is installed in an unknown or
unsupported chassis. You must upgrade the firmware to a newer
124
SPARC T8-1 Server Service Manual • January 2022
"Replace the Top Cover" on page
"Return the Server to the Normal Operating Position" on page
"Attach Power Cords" on page
157.
159.
158.
Advertisement
Table of Contents
