Table of Contents
Advertisement
You will hear an audible click when the power supply is fully seated.
4.
Reconnect the power cord to the power supply.
5.
If you disconnected the two CMA left-side connectors, reconnect the CMA.
For instructions on reconnecting the CMA see
Server Installation
Verify that the AC OK LED is lit.
6.
See
"Locate a Faulty Power Supply" on page
7.
Verify that the following LEDs are not lit:
Service Required LED on the power supply
■
Front and rear Service Required LEDs
■
Rear PS Failure LED on the bezel of the server
■
See
"Interpreting LEDs" on page
8.
"Verify a Power Supply" on page
Guide.
27.
82.
"Attach the CMA to the Server" in SPARC T8-1
77.
Servicing Power Supplies
Install a Power Supply
81
Advertisement
Table of Contents
