Oracle SPARC T8-1 Service Manual page 67

c0
c0::dsk/c1t0d0
c0::sd1
usb0/1
usb0/2
...
3. Configure each drive that is not already configured.
For example, to configure the second disk listed in
# cfgadm -c configure c0::sd1
Replace c0::sd1 with the drive name for your configuration.
4. Verify that the blue Ready to Remove LED is no longer lit on the drive that you
installed.
See "Determine Which Drive Is Faulty" on page
5. At the Oracle Solaris prompt, list all drives in the device tree, including any
drives that are not configured.
# cfgadm -al
The replacement drive is now listed as configured, as shown in the following example.
Ap_Id Type
c0 scsi-bus
c0::dsk/c1t0d0 disk
c0::dsk/c1t1d0 disk
usb0/1 unknown
usb0/2 unknown
...
Perform one of the following tasks based on your verification results:
6.
If the previous steps did not verify the drive, see
■
Faults" on page
If the previous steps indicate that the drive is functioning properly, perform
■
the tasks required to configure the drive. These tasks are covered in the
Oracle Solaris OS administration documentation.
For additional drive verification, you can run Oracle VTS. Refer to the Oracle VTS
documentation for details.
scsi-bus connected
disk connected
disk connected
unknown empty
unknown empty
Receptacle
connected
connected
connected
empty
empty
21.
configured unknown
configured unknown
unconfigured unknown
unconfigured ok
unconfigured ok
Step 2, type:
61.
Occupant Condition
configured unknown
configured unknown
configured unknown
unconfigured ok
unconfigured ok
"Detecting and Managing
Verify a Drive
Servicing Drives 67