Operation
4.27.7 Tape feeder and automatic cutter
The electromotive, length-controlled tape feeder with automatic cutter
transports the reinforcement strip under the pocket opening and cuts it off
at the seam end.
The process is carried out during the cycle time. No further positioning and
working times are required.
Inserting the reinforcement strip
Fig. 55: Tape feeder and automatic cutter (1)
(1) - Guide
(2) - Tape monitor
(3) - Advancing device
To insert the reinforcement strip:
1. Loosen the locking lever (6) and pull the washer (5) off to the side.
2. Insert the tape roll as shown above.
3. Place the washer (5) and tighten the locking lever (6).
4. Feed the reinforcement strip (4) from bottom to top through the advanc-
Operating Instructions 755 B, 756 B/F - 00.0 - 02/2021
①
②
③
④
Ensure that the tape roll is clamped securely.
ing device (3).
(4) - Reinforcement strip
(5) - Washer
(6) - Locking lever
⑥
⑤
63