Table of Contents
Advertisement
4.26 Stripe correction (class 756 only, method F)
The stripe correction can only be used in combination with the turning
device for flaps.
You adjust the stripe correction at the OP7000 control panel.
Program parameters > Pattern matching ( p. 184).
Fig. 45: Stripe correction (1)
(1) - Flap stopper
To adjust the stripe correction:
1. Insert piping.
2. Place the flap into the retracted and open turning device.
3. Position the flap in the longitudinal direction relative to the jacket front
4. At the same time, position the flap at the lowered mechanical flap
5. Press the left pedal forward.
The clamping bar closes and holds the flap in place. The mechanical
6. Press the right pedal backwards.
The vacuum is switched off.
56
part, which must be aligned and fixed in place by vacuum.
Depending on the model, the flap projects 10 to 15 mm over the breast
dart.
stopper (1).
flap stopper swivels up.
Operating Instructions 755 B, 756 B/F - 00.0 - 02/2021
Operation
①
Advertisement
Table of Contents
