Table of Contents
Advertisement
5. Insert the reinforcement strip (4) into the guide (1) behind the tape
Fig. 56: Tape feeder and automatic cutter (2)
(4)
(7) - Knurled screws
(8) - Knurled screws
6. Feed the reinforcement strip (4) into the guide (9).
7. Pull down the hook (10) and the reinforcement strip (4) until the rein-
Information
You can use knurled screws (7) to adjust the guide (9) individually to the
width of the reinforcement strip (4), while knurled screws (8) let you make
a lateral adjustment of the guide (9) as a whole.
8. Switch on the machine.
9. Press the
The reinforcement strip (4) is cut to the correct length.
Information
The setting for the tape projection at seam beginning and seam end is
made using the OP7000 control panel. Program parameters >
Automatic tape feeder ( p. 162).
64
monitor (2).
④
⑦
⑧
⑨
- Reinforcement strip
forcement strip (4) juts out through the cutout in the fabric sliding plate.
button.
(9) - Guide
(10) - Hook
Operating Instructions 755 B, 756 B/F - 00.0 - 02/2021
Operation
⑩
⑦
⑧
Advertisement
Table of Contents
