Table of Contents
Advertisement
Operation
15. Press the right pedal forward.
The vacuum is switched on to fix the jacket front part in place.
16. Press the left pedal forward.
The flap turning device swivels up and turns the flap (15).
17. Press the left pedal forward.
Holding the picked-up and incised piping strip, the pick-up folder (16)
18. Press the left pedal forward.
The feeding device (14) with the flap (15) swivels in.
19. Press the left pedal forward.
The sewing process starts.
Positioning correction
To make positioning corrections:
1. Press the left pedal back.
Information
Any visible offset of checks / stripes after the flap has been pulled through
the respective jacket front part can be compensated by making adjust-
ments at the control panel.
You adjust the stripe correction at the control panel OP7000.
Program parameters > Pattern matching ( p. 56 and p. 184)
Operating Instructions 755 B, 756 B/F - 00.0 - 02/2021
The feeding device (14) grasps the flap (15) and clamps it.
The transport carriage moves to the loading position.
The transport clamps are lowered.
swivels into the vertical position and lowers the jacket front part.
The folding plates close.
The feeding device (12) holding the pocket bag (11) swivels in.
The flap clamps on the transport clamps close.
st
• 1
pedal tap: The flap clamps open
nd
• 2
pedal tap: The feeding devices swivel back
rd
• 3
pedal tap: The folding plates open, and the pick-up folder
swivels back to its initial position
th
• 4
pedal tap: The transport clamps lift
th
• 5
pedal tap: The transport carriage returns to its waiting position
95
Advertisement
Table of Contents
